GATOR RACK INSTRUCTIONS

1. Insert the brass nail taped to the QR card into the small hole underneath the GATOR RACK. Pop out the copper pin and separate the rack from the back piece. 
   
   

2. Place the back piece on the wall where you want your GATOR RACK to be (Make this a spot with a wall stud for maximum strength.). Using a pencil, mark the wall through the two holes. 
   
   TIP: Use a level to make sure the piece is perfectly straight before marking the wall. 
   
   

3. Using a 3/16” drill bit, drill two holes, one at each pencil mark, straight into the wall. 
   
   NOTE: If you are not drilling into a stud, you will need a 1/2” drill bit in order to use the anchors included with the bolts. 
   
   

4. Screw the back piece onto the wall using the two bolts provided. Ensure that it is firmly fixed before continuing.
   
   

5. Slide the front piece of the GATOR RACK back onto the back piece. 
   
   

6. Re-insert the copper pin in the hole at the top of the GATOR RACK. Push down on the pin until it’s flush with the surface of the wood and you can smoothly run your fingers over it. 
   
   

You’re all set to display your bike in style! If you have any questions or concerns, don’t hesitate to email us. We get back to most emails in one business day.